-
About UsYongbang dry spirit of enterprise is "practical work, humility, peaceful competition, development and development". It is under the inspiration of this spirit that we have embarked on the road of establishing and building Yongbang enterprises. Yongbang Dry and Yongbang Intelligence are a group of young intellectuals. We follow the behavior principle of "peaceful competition, development and development". To be the master of modern economy and the standard bearer of new energy equipment.
-
Products
-
-
-
News Center
INDUSTRY CASES
Industry case
CT, CT-C series hot air circulation oven
CT, CT-C series of hot air circulation oven by our company carefully designed, constantly updated a product. The equipment is a box type, which can be assembled and disassembled. It is divided into CT type (centrifugal fan) CT-C (axial flow fan) series of products. It uses steam and electricity as heat sources and is heated by heaters. A large amount of hot air circulates in the box. After continuous fresh air supplement, it enters the box from the air inlet and then continuously discharges from the humidity outlet, thus increasing the heat transfer effect and gradually reducing the moisture content of the materials in the box. The oven produced by our company is equipped with low noise, high temperature resistant axial flow fan and automatic temperature control system. The whole circulation system is fully enclosed, so that the thermal efficiency of the oven is increased from 3-7% in the traditional oven to 35-40% at present, and the high thermal efficiency can reach 70%. The device was issued an industry standard by the State Administration of Medicine in 1990, and the same model is RXH.
QF type enhanced boiling airflow dryer
Enhanced boiling airflow dryer is a new type of continuous drying equipment integrating drying, crushing and screening. It is a dryer dominated by hot air convection drying. The equipment is constantly improved and developed on the basis of fixed boiling fluidized bed dryers and fluidization dryers such as airflow. The equipment can supplement dry hot air for secondary drying of undried materials, so that the moisture content of finished products can be effectively controlled below 0.1%.
Airflow drying, also known as "instant drying", is the application of dilute phase transport in solid fluidization in drying. The characteristic of the pulse air flow dryer is that the diameter of the air flow drying tube is alternately reduced and expanded, and the diameter of the tube is alternately reduced and expanded, so the movement velocity of the particles is also alternately accelerated and decelerated, and the relative velocity and heat transfer area between the air and the particles are large, thus enhancing the heat and mass transfer rate.
DWT type through-flow belt dryer
DWT series belt dryer is the second generation belt drying equipment developed and produced by our company. The main structural feature is that the heat exchanger is placed at the upper and lower positions of the mesh belt. The hot air circulation mode is longitudinal multi-unit series circulation, which has the advantages of uniform heating and high heat utilization rate. It can be used for the drying of sheet, strip, granular and partial paste materials with good air permeability.
XMG-M Type Nitrogen Circulating Flash Dryer
Nitrogen circulating flash dryer nitrogen under the protection of extremely low oxygen conditions, product quality is good, to avoid the risk of oxidation, decomposition, combustion and explosion. It is suitable for the drying of inflammable, explosive and toxic cake-like, paste-like and slurry-like materials containing organic solvents and the recovery of organic solvents.
Nitrogen closed circuit spray dryer
The nitrogen closed-circuit spray dryer consists of a centrifugal spray dryer main machine, a heater with an air filter, a blower, a gas-liquid separator, a large and small condenser, a spray tower, an exhaust fan, a primary cyclone separator, a secondary cyclone separator, a pump, an oxygen detector, pipelines and control valves, etc. As a special equipment for drying organic solvent slurry, the nitrogen closed-circuit spray dryer is dried by nitrogen..
PLG-M type nitrogen circulating disc dryer
Nitrogen circulating disc dryer is the optimization and upgrading of traditional explosion-proof disc drying technology. It can solve the problems of organic solvent recovery, easy oxidation and drying of toxic materials. It is suitable for free-flowing, non-adhesive, extremely fine powder (below 100 mesh) and granular materials with wide particle size distribution, drying of materials containing organic solvents and recovery of organic solvents.
BPG type nitrogen closed loop rake dryer
Yongbang developed a new type of closed-loop rake dryer combined with the advantages of various existing dryers to develop a new type of dryer, which has a wide range of process applicability and solves new problems raised by modern production processes. The new equipment is aimed at the needs of powder drying process in the field of chemical industry and feed, and provides a compound heat transfer drying equipment with high efficiency, wide application range of powder and high drying effect.
Service Hotline
Address: No. 28, Park Road, Bieqiao Town, Liyang City, Changzhou City, Jiangsu Province, China
E-mail: yongbang@jsybzn.cn
WeChat public number
Get more services
Copyright©2024 Jiangsu Everland Intelligent Equipment Technology Co., Ltd. www.300.cn | SEO